🔥 | Latest

Flexing, Waves, and Control: LOCR TENSION The FlickLock requires correct tensioning to perform properly. If slipping of the lower section occurs, open the lever and tighten the adjustment screw about a quarter to a half turn, or until the mechanism does not allow the shaft to slip once the lever is closed. If the lever becomes too difficult to snap shut, loosen the screw a bit USING THE FLICKLOCK PRO MECHANISM The patented FlickLock® Pro is an external camming mechanism that, when closed, squeezes the pole shafts together to form a joint stronger than the tubing itself. The best way to open the FlickLock Pro is to hold the pole as shown in Figure 3 while pushing the cam lever open with your thumb. Once the lever is open, adjust the lower shaft to the desired length. Then close the lever firmly so that the lever "snaps" over the lower shaft. This will prevent the FlickLock Pro from accidentally opening in the event of a strong side load. ADJUSTING FLICKLOCK PRO TENSION edge cu ela not des na puouwe!pypejq@ujeunow eua u °כ .lapqo uielu nou:l.euu® BAT IC adjusted and sliding of the lower section occurs the adjustment screw (about an mechanism does not allow the shaft lever becomes too difficult to snap lickLock Pro tension is pre should not require adjustment. If however, open the lever and tigh eighth to a quarter turn) until t to slip once the lever is closed. If the shut, loosen the screw a bit. CONTROL SHOCK Some poles come equipped with Black Diamond's Control Shock, which both reduces impact fatigue and controls pole rebound. This three stage elastomeric shock absorber uses an air bleed return system for controlled rebound CHANGING TIPS rt UT lor La Co Most trekking poles come with carbide Tech Tips installed and optional rubber tips are available. To remove the Tech Tips, twist counter-clockwise and unscrew. Tech Tips are designed with a wave-shaped rubber locking system to prevent them from coming off during use. You will have to twist them forcefully enough to override the wave-shaped bumps. You may be able to do this with your fingers or you may need to use pliers. To install new tips, twist them in by hand or with pliers. Once the wave-shaped bumps make contact with the waves on the tip, they should twist 4-5 clicks until very snug. Rubber tips should bulge out slightly when they are completely tightened. Some models of trekking poles come with traditional Flex Tips. To remove, the Flex Tip needs to be heated (submerge in boiling water) and pulled off with pliers. Firmly push the new Flex Tip onto the tip of the pole. PERIODIC CLEANING The lower shaft(s) can pull out completely from the wpper shaft when the Fliplock Pro tension is pre-should not require adjustment
Flexing, Waves, and Control: LOCR
 TENSION
 The FlickLock requires correct tensioning to
 perform properly. If slipping of the lower section
 occurs, open the lever and tighten the adjustment
 screw about a quarter to a half turn, or until
 the mechanism does not allow the shaft to slip
 once the lever is closed. If the lever becomes too
 difficult to snap shut, loosen the screw a bit
 USING THE FLICKLOCK PRO MECHANISM
 The patented FlickLock® Pro is an external camming
 mechanism that, when closed, squeezes the pole
 shafts together to form a joint stronger than the tubing
 itself. The best way to open the FlickLock Pro is to
 hold the pole as shown in Figure 3 while pushing the
 cam lever open with your thumb. Once the lever is
 open, adjust the lower shaft to the desired length. Then
 close the lever firmly so that the lever "snaps" over the
 lower shaft. This will prevent the FlickLock Pro from
 accidentally opening in the event of a strong side load.
 ADJUSTING FLICKLOCK PRO TENSION
 edge cu
 ela
 not des
 na puouwe!pypejq@ujeunow eua
 u °כ .lapqo
 uielu nou:l.euu®
 BAT
 IC
 adjusted and
 sliding of the lower section occurs
 the adjustment screw (about an
 mechanism does not allow the shaft
 lever becomes too difficult to snap
 lickLock Pro tension is pre
 should not require adjustment. If
 however, open the lever and tigh
 eighth to a quarter turn) until t
 to slip once the lever is closed. If the
 shut, loosen the screw a bit.
 CONTROL SHOCK
 Some poles come equipped with Black Diamond's Control Shock, which
 both reduces impact fatigue and controls pole rebound. This three
 stage elastomeric shock absorber uses an air bleed return system for
 controlled rebound
 CHANGING TIPS
 rt
 UT
 lor
 La
 Co
 Most trekking poles come with carbide Tech Tips installed and optional
 rubber tips are available. To remove the Tech Tips, twist counter-clockwise and
 unscrew. Tech Tips are designed with a wave-shaped rubber locking system
 to prevent them from coming off during use. You will have to twist them
 forcefully enough to override the wave-shaped bumps. You may be able to do
 this with your fingers or you may need to use pliers. To install new tips, twist
 them in by hand or with pliers. Once the wave-shaped bumps make contact
 with the waves on the tip, they should twist 4-5 clicks until very snug. Rubber
 tips should bulge out slightly when they are completely tightened.
 Some models of trekking poles come with traditional Flex Tips. To remove,
 the
 Flex Tip needs to be heated (submerge in boiling water) and pulled off
 with pliers. Firmly push the new Flex Tip onto the tip of the pole.
 PERIODIC CLEANING
 The lower shaft(s) can pull out completely from the wpper shaft when the
Fliplock Pro tension is pre-should not require adjustment

Fliplock Pro tension is pre-should not require adjustment

Life, Got, and Who: Life can be so unfair Y'all, I just got broken up with by a guy who used me as a rebound and lied about it. It hurts, man
Life, Got, and Who: Life can be so unfair
Y'all, I just got broken up with by a guy who used me as a rebound and lied about it. It hurts, man

Y'all, I just got broken up with by a guy who used me as a rebound and lied about it. It hurts, man

Goals, Hockey, and Slick: The Original Brunswick airhXckey GAME Now available in three models! The original air-cushion table game that has swept the country. Captures all the speed, action, and excitement of ice hockey in your own recreation room! New TOURNAMENT t, professional-style 7-foot table model has a tough Melamine bed. Commercial quality U.L. approved electric blower motor with handy on/off switch. Built-in scorecounters. Durable heavy-duty, large aluminum rail extrusions for fast rebound and professional play. Shoot through goals ieiamine bed, Comiechal quality sharpen both offensive and defensive skills. Professional style 6-foot table model has exclusive super-slick, acrylic SPEEDMASTER™ bed. Balanced bed construction for maximum stability and lasting strength. Built-in score- counters. Comes complete with two hi-profile lies and two professional pucks. Heavy- roved electric blower motor with on/off switch. The 6-foot table model has other features similar to 7-foot table model BANTAMT 5-foot table model is similar to 6-foot professional-style. Extruded alumi- num rails. Complete with two hi-profile goalies, and two pucks. (Scorecounter not included) 5' size table (Code #260-71-050) 6' size table (Code #260-71-060) 7' size table (Code #260-70-070) TOURNAMENT' 7-foot table model with scorecounter Professional-style 6-foot table model Comes with scorecounter U.S. Pat. Nos. 3,871,585 and 3,887,187 Other U.S. & International Patents Pending & Issued. BANTAM 5-foot table model. Comes without scorecounter Brunswick Air Hockey [1977]
Goals, Hockey, and Slick: The Original
 Brunswick
 airhXckey GAME
 Now available in three models!
 The original air-cushion table game that has swept the
 country. Captures all the speed, action, and excitement
 of ice hockey in your own recreation room!
 New TOURNAMENT t, professional-style 7-foot table
 model has a tough Melamine bed. Commercial quality
 U.L. approved electric blower motor with handy
 on/off switch. Built-in scorecounters. Durable
 heavy-duty, large aluminum rail extrusions for fast
 rebound and professional play. Shoot through goals
 ieiamine bed, Comiechal quality
 sharpen both offensive and defensive skills.
 Professional style 6-foot table model has
 exclusive super-slick, acrylic SPEEDMASTER™
 bed. Balanced bed construction for maximum
 stability and lasting strength. Built-in score-
 counters. Comes complete with two hi-profile
 lies and two professional pucks. Heavy-
 roved
 electric blower motor with
 on/off switch. The 6-foot table model has
 other features similar to 7-foot table model
 BANTAMT 5-foot table model is similar to
 6-foot professional-style. Extruded alumi-
 num rails. Complete with two hi-profile
 goalies, and two pucks. (Scorecounter not
 included)
 5' size table (Code #260-71-050)
 6' size table (Code #260-71-060)
 7' size table (Code #260-70-070)
 TOURNAMENT' 7-foot table model
 with scorecounter
 Professional-style
 6-foot table model
 Comes with scorecounter
 U.S. Pat. Nos. 3,871,585 and 3,887,187
 Other U.S. & International Patents
 Pending & Issued.
 BANTAM 5-foot table model.
 Comes without scorecounter
Brunswick Air Hockey [1977]

Brunswick Air Hockey [1977]